Flash Integration Setup US Agents

Setting up the connection and mapping brands

Parent Brand Entry

To access the Flash configuration in OASIS, Select manufacturers, then open the "Cooper" entry. This MUST be set up as a "Parent(shown)" entry.  Check the "Merge Brands" check box. If the specialization is not already set to "Flash", then select "Flash" in the drop down list - otherwise press the "Configure Specialization" link.

When the configure link is pressed the Flash configuration window will appear.

**NOTE: If you have any of the child brands mapped to the parent Cooper manufacturer contact support immediately.  This could mess with your Cooper pricing in OASIS.**

Child Brands

Users should create a Manufacturer entry for each child brand.  Select Cooper as the parent and click the "Merge Brands" check boxes for all brands that can be sent together in a single order. 

"Cooper Core" Manufacturers

The following Cooper manufacturers are part of the core Cooper lines. They should each have their own manufacturer entry in OASIS (or one entry with two or more brands mapped to it, as with Halo (HALO-Rec and Halo-Trac). These should have Cooper  set as the parent company and have the "Merge Brands" box checked.

Select "Cooper" from the ellipse (click the "..." button).  Then under Brands map ONLY brands that correspond to the child manufacturer entry.  For example, Halo-Trac and Halo-Rec should be mapped to one Halo manufacturer entry, unless there are already individual child brands created for Halo-Trac and Halo-Rec- in that case, Halo-Rec should be mapped to Halo-Rec and Halo-Trac should be mapped to Halo-Trac.  

Non "Cooper Core" Manufacturers

DO NOT select "Merge Brands" for non Cooper Core manufacturers.  The manufacturers in the list below are not part of the core Cooper lines and must be quoted and ordered independently in OASIS. 

1. Corelite

2. Neoray

3. Specialty Products

a. Ametrix

b. IO Lighting

c. RSA

d. Shaper

The 3 brands above should still have the parent company set to Cooper Lighting under the identification section on the general tab of the Cooper child manufacturer. Each of the brands above should also have their specialization set to Flash under the connectivity section on the general tab of the Cooper child manufacturer.  One example, the Corelite non core Cooper child brand, can be seen below. 

After clicking on "Configure Specialization" click on the ellipses and select the corresponding brand.  For the example above, select "Corelite" as the brand from the ellipses.  The text on the configuration window should change from "Cooper" to "Corelite". 

Click "OK" to save and close.